Reverse Order Printing; Page Reduction - Ricoh C2408 Operating Instructions Manual

Reception Features
Note
❒ Your service representative can
customize this function with the
following settings.
• Reduction
• Print split mark
• Overprinting
• Overprinting length
• Guideline for split
❒ You can adjust the overprinting
and reduction lengths within the
following ranges:
• Overprinting length: 4mm (0.16"),
10mm (0.39"), 20mm (0.79")
• Guideline for split: 0∼155mm
5
(5mm steps)/0∼6.1" (0.2" steps)

Reverse Order Printing

Normally, received pages are printed
and stacked on the tray in the order
they are received. If you turn this
function on, the machine will start
printing the message from the last
page received.
Note
❒ You can turn this function on or off
with the Reception Mode. See
p.104 "Reception Mode".
❒ When this function is on, the first
page will be printed last.
❒ This function uses Memory Recep-
tion.
74

Page Reduction

If you receive a message that is longer
than the paper in the cassette, usually
the machine prints it on two pages. If
you turn this function on, the ma-
chine reduces the width and length of
the received image so that it will fit on
one page. If A4L paper size is loaded
and a message of B4L size is re-
ceived, the machine will reduce the
message to a single A4L sheet.
Note
❒ You can turn this function on or off
with the User Parameters. See
p.113 "Changing the User Parame-
ters" (Switch10, Bit3).
❒ When this function is used, the
printing quality may not be as
good as usual.
Reference
See p.73 "Page Separation and
Length Reduction".