Panasonic KX-TD816 Features Manual page 291

Conditions
• UCD can be used in the following cases:
a) The floating number of UCD is assigned as the Direct In Lines (DIL) 1:1 destination.
b)
The floating number of UCD is assigned as the Intercept Routing destination.
c)
The floating number of UCD is dialed from an extension.
d)
The floating number of UCD is dialed from DISA (Direct Inward System Access)
e) The floating number of UCD is assigned as the UCD Overflow destination.
• This feature requires assigning an UCD group in System Programming. An extension
cannot belong to two or more UCD groups.
• The floating number can be assigned on an UCD group basis. The UCD group is based on
the extension group.
• It is possible to set the log-in or log-out status on an extension basis. An UCD call can be
sent to an extension in log-in status within the UCD group, but cannot be sent to extensions
in log-out status. If the extension would like to leave the group temporarily, the extension
sets the log-out status by the feature number to prevent UCD calls being sent to his/her
extension. When the extension re-joins the group, the extension sets the log-in status.
• There should be at least one extension that is in log-in status. Or all extensions can be
assigned to be in log-out status in System Programming.
Programming Guide References
• [106] Station Hunting Type
• [122] UCD Overflow
• [123] UCD Time Table
• [602] Extension Group Assignment
• [813] Floating Number Assignment
• [990] System Additional Information
• [991] COS Additional Information
Features Guide References
• Extension Group
• Floating Station
• Log-In / Log-Out
• Ring Group
• Station Hunting
User Manual References
• 4.3.87 Uniform Call Distribution (UCD)
Available for the KX-TD1232 only.
*1
Features Guide
General Features
*1
291