Panasonic KX-TD816 Features Manual page 256

General Features
n) Examples for the program [728] T1 Extension Outgoing Permitted Outside Line
Assignment — Day
The assignment to enable outside lines on CO No.s (01-24) to be made from the T1
extension 01
In the example on the previous page;
T1 channel No. 01 (CO No. 25) refers to the data assigned in program [728] for the CO
No. 01.
And then the T1 extension 01 can make an outside line on CO No. 25.
T1 channel No. 09 (CO No. 33) refers to the data assigned in program [728] for the CO
No. 09. And then the extension 01 cannot make an outside line on CO No. 33.
o) Examples for the program [729] T1 Extension Outgoing Permitted Outside Line
Assignment — Night
The assignment to enable outside lines on CO No.s (01-24) to be made from the T1
extension 01
In the example on the previous page;
T1 channel No. 01 (CO No. 25) refers to the data assigned in program [729] for the CO
No. 01.
And then the T1 extension 01 can make an outside line on CO No. 25.
T1 channel No. 09 (CO No. 33) refers to the data assigned in program [729] for the CO
No. 09. And then the extension 01 cannot make an outside line on CO No. 33.
• Enables to send a Caller's extension number to each outside line assigned on a TIE line in
program [720] T1 TIE Ringing Service. If a call with a Caller's extension number is
received, only the Caller's extension number will be displayed (Caller's extension name
will not be displayed). If a PBX code is assigned, "PBX code + Caller's extension number"
will be displayed. This feature is only available between Panasonic PBXs.
• Enables to send a dial tone to the other party, if each outside line assigned on the TIE line
is used.
• For a DID line, refer to "Direct Inward Dialing (DID)".
• For a TIE line, refer to "TIE Line Service".
• If a DID / TIE is assigned, the automatic function for disconnection will work.
It is a function to disconnect the line if the called party does not answer with in the assigned
time.
The time can be assigned 0, 1, 2 or 3 minutes on program. (0 is not to disconnect, 1 is the
default.)
<Extension Line Assignment – OPX>
• If OPX is assigned, a single line telephone installed to out of PBX can perform through the
T1 line like an extension installed to PBX.
• If OPX is set, as a default for an extension number has not been assigned, it must be
assigned by programming.
• An extension line set OPX can be assigned a name. On receiving an extension line call from
OPX, the extension number and name is displayed on LCD.
• An extension line set OPX can be assigned COS and regulated depending on it.
• An extension line set OPX can be regulated to connect to an outside line.
• The valid features for an extension line set OPX are as follows.
a) Class of Service
256 Features Guide