Panasonic KX-TD816 Features Manual page 263

Programming Example
<Example>
Your system is PBX-1 and there are four PBXs in your TIE line network. To identify the
outside line route as illustrated below, you should make the following routing table.
If you dial:
a) N-952-xxxx
b) N-953-xxxx
c) 2xx
(N: TIE line access code)
Location
No.
01
02
03
Explanation
Location 01: The hunt sequence by dialing [N+PBX Code 952]:
The 1st route — Outside line group (TRG) 5
The 2nd route — Outside line group (TRG) 6
Location 02: The hunt sequence by dialing [N+PBX Code 953]:
The 1st route — Outside line group (TRG) 6
The 2nd route — Outside line group (TRG) 5
Location 03: The hunt sequence by dialing [Ext.no. 2xx]:
The 1st route — Outside line group (TRG) 7
If the received number does not match the PBX Code, the system checks the number in the
routing table. If it is found, the system automatically sends the number to the corresponding
PBX.
For example, if PBX-1 receives the number "952-xxxx" from PBX-4, PBX-1 automatically
sends the number through Outside line group 5.
Features Guide
PBX-4
Ext. 2xx
c)2xx
TRG 7
Ext. 1xxx
PBX Code 951
PBX-1
TIE Line Routing Table of PBX-1
PBX Code Removed
/ Ext. No. Digit
952 0
953 0
2xx 0
TIE Line Network
TRG 6
b) 953-xxxx
TRG 5
a) 952-xxxx
Outside Line Group Hunt Sequence
Added
Digit
01 02
5 6
6 5
7
General Features
PBX-2
Ext. xxxx
PBX Code 953
Ext. xxxx
PBX Code 952
PBX-3
03 04 05
263