Assemble The Carry Case; Carry Case With Metal Snaps - Honeywell MX8 User Manual

Assemble the Carry Case

Note: Honeywell recommends that accessory installation or removal be performed on a clean, well-lit
surface. When necessary, protect the work surface, the MX8, and components from electrostatic
discharge.
1. Remove any cables connected to the I/O port at the bottom of the MX8.
2. Remove the rubber boot from the MX8.
3. Separate the hook and loop fabric on the carry case without removing the hook and loop fabric from the carry case.
4. Slip the removable, clear plastic protector for the keypad and touchscreen into the case. Position it against the openings
for the keypad and touchscreen in the case. The voice case does not require the clear plastic protector.
5. Slide the MX8 into the case, making sure the touchscreen and keypad (including the Scan LED) are visible and
accessible through the front openings of the case.
6. Securely tether the stylus to the case, if necessary. Place the stylus in the stylus holder on the handstrap or in the
trigger handle.
7. Loosen then tighten the handstrap (on cases without a trigger handle opening) until the carry case assembly is secure in
your hand.
8. When a shoulder strap is available,secure the clips at each end of the shoulder strap to the D rings on either side of the
carry case. The shoulder strap allows the MX8 to hang upside down until needed.
The main battery can be removed and inserted without taking the MX8 out of the carry case.

Carry Case with Metal Snaps

The metal snap has a bulge in the lip and a dot indentation on the opposite side. To snap the cap closed, tuck the lip bulge
under the snap lip and press on the dot to snap closed.
Pull the snap up to open.
2-20