Voice Case Assembly - Honeywell HX2 User Manual

Voice Case Assembly

The voice case is a sturdy, lightweight covering for the HX2, tethered battery, and voice accessories. The voice case cannot
protect the HX2 from destructive, excessive force or a harsh or wet environment. It is designed to protect the HX2 from dirt,
dampness, and minor, trivial bumps.
1. Slide the belt through the belt loop on the voice case. Do not put the belt on yet.
2. Attach the battery cable, ring scanner and audio headset to the HX2.
3. Slip the HX2 into the voice case. Be sure the screen and keypad are visible through the clear window of the voice case.
4. Slide the battery cable through the protective loop at the bottom of the voice case. Make sure the tethered cable for the
ring accessory is on the outside of the voice case.
5. Slip the battery into the battery sleeve and connect the battery to the battery cable. The battery charge terminals (small
metallic circles) should always be covered by the sleeve.
6. Press the hook and loop fabric at the top of the device together.
7. The HX2 in the Voice Case is ready for use.
8. Put the belt on. Adjust the belt and voice case for comfort.
Examine the tethers and the hook and loop fabric fastening periodically. If any are loose or unfastened, tighten the tethers and
the top fastener before placing the voice case back into service. If the voice case is damaged, it should be removed from
service.
1. Voice Pouch
2. Alternative Battery Placement
3. Headset
4. Audio Cable
5. Ring Scanner Extended Cable
6. Wrist Strap
7. Clothing Clips
2-7