Arm Condition Memory - Mongoose M60i Owner's Operation Manual

GLASS BREAK SENSOR (M60G MODELS – optional on other models)
This sensor is designed to trigger the alarm by detecting the sound of actual glass breakage.
The sensitivity level is set by the installer and should be at its optimum.
2 STAGE IMPACT SENSOR (MODELS M60B/S/G)
This sensor is designed to detect impacts to the vehicle. It should not be triggered by normal wind,
or rocking motions.
If the sensor detects a light impact, the siren will sound a few warning chirps.
If the sensor detects a heavier impact, the siren will sound fully and the lights will flash for
30 seconds.
The sensor is adjustable for sensitivity and is set by the installer.
(This type of sensor may not detect the theft of wheels, we therefore advise the fitment of locking
wheel nuts and our self levelling electronic tilt sensor)
BATTERY BACK-UP SIREN (M60S/G – optional on other models)
Vehicle battery disconnection or cutting the siren wires will cause the battery back-up siren to
sound independently of an alarm trigger. The siren can be turned off with the special keys
provided. You should turn the siren off whenever the car battery needs attention or changing.
CAUTION: Check that the siren has been mounted in such a position so as to avoid water ingress or
heat damage. If washing the engine bay, cover the siren with a plastic bag to prevent water damage.
Heat or water damage is not covered by the warranty.

ARM CONDITION MEMORY

Should the vehicle battery be disconnected, the system memorises the last set position of the alarm.
If the battery was disconnected whilst the system was armed, reconnection will return the system to
the armed state and may trigger the siren.
9