Automatic Re-Set; Arm Condition Memory - Mongoose MX40 II Series Operating & Installation Instructions Manual

SECURITY RE-ARM (& RE-LOCK)
The system will automatically re-immobilise after 30 seconds if it has been disarmed by remote.
Doors will also re-lock, if connected, if no door is opened within the 30 seconds. Opening a door will
not prevent the engine from being automatically immobilised – the engine must be started to prevent
this. For the security re-lock feature to operate, the system must have been initially set by the remote
control.
TRIGGER & 2 STAGE DISARM
When armed, if a door is opened or the ignition is switched on the park lights will flash for 30 seconds
(the optional siren will sound).
If the system is being triggered, press the disarm button once to cancel the lights and optional siren.
Press a second time to disarm the system.

AUTOMATIC RE-SET

After the system has been triggered, it will automatically re-set to the armed position. If the parking
lights flash 4 times upon disarming, this indicates the system has been triggered.

ARM CONDITION MEMORY

Should the vehicle battery be disconnected, the system memorises the last set position of the system.
If the system was disarmed and the engine not immobilised prior to battery disconnection,
reconnection does not immobilise the vehicle until reset by the ignition being turned ON then OFF.
If the battery was disconnected whilst the system was armed, reconnection will return the system to
the armed state and then immediately trigger.
PARK LIGHTS FLASHING (connection to the indicators may infringe your warranty)
The park lights flash to confirm the arming and disarming of the system. They will also flash if the
system is triggered whilst the system is armed. The park light output is fuse protected to prevent the
module being shorted.