Anti-Hijack; Arm Condition Memory; Chirp Confirmation Codes; Dash Mounted Warning Light (Led) - Mongoose M30 Owner's Operation Manual

ANTI-HIJACK (default is OFF)
In the event of an attempted vehicle theft whilst driving, press
sound periodically and the lights will flash until UNLOCK is pressed to cancel. This will also immobilise the engine if
programmed on.
To turn engine kill on: Press UNLOCK and
To turn engine kill off: Repeat above. Two chirps confirm

ARM CONDITION MEMORY

Should the vehicle battery be disconnected, the system memorises the last set position of the alarm. If the alarm was
disarmed, reconnection does not cause the alarm to sound. If the battery was disconnected whilst armed,
reconnection will cause the system to trigger. To cancel, disarm with the remote control.
ALARM CHIRP CONFIRMATION CODES
This is an audible indication of system status.
A) 1 Chirp - Armed
B) 2 Chirps - Disarmed
C) 2 Chirps, then 1chirp after door open – Disarmed and indicates the alarm has been triggered
D) 3 Chirps – Arming reminder or light impact of shock sensor
E) Chirps for 15 seconds – Heavy impact of shock sensor or 'panic'
DASH MOUNTED WARNING LIGHT - LIGHT EMITTING DIODE (LED)
The dash mounted LED shows the status of the alarm;
A) Twice then pause
B) Three times then pause
B) ON for 2 sec's then pause
C) LED off
D) Continuously lit
for 2 seconds to activate anti-hijack. The siren will
for 2s with ignition on. One chirp confirms
- System armed
- Alarm triggered by impact
- Alarm triggered by doors, bonnet or boot.
- System off
- Valet mode
7