Silent Arming & Shock Sensor Bypass 6 Auto Re-Set; Panic; Electronic Siren; Indicator Flashing - Mongoose M20 Owner's Operation Manual

SILENT ARMING
Press both buttons to silently arm the system without the siren chirps. Disarming is then automatically silent.
AUTOMATIC RE-SET
The siren will sound for 5 to 30 seconds, depending on the circuit triggered, after which it will stop and reset to the
armed position. It will then re-trigger on the next intrusion or if a circuit was left open.

PANIC

In the event of personal attack, the alarm can be 'panicked' for 6 seconds by pressing remote control button one
for more than 2 seconds. Holding down the remote button causes the panic to be continuous.
Panic mode does not operate with the ignition on or if the system is disarmed.
ELECTRONIC SIREN (M20S has a battery back-up siren)
This is mounted under the bonnet and must be situated in a place to protect it from heat and water damage such
as driving through deep water or engine cleaning. It must be mounted with the siren pointing down.
If washing the engine bay, cover the siren with a plastic bag to prevent damage. Heat or water damage is not
covered by the warranty.
INDICATORS LIGHTS FLASHING
When the siren sounds, the indicators flash. If 'shorted', the siren continues to sound. The indicators will also flash
on arming and disarming the system.

ARM CONDITION MEMORY

Should the vehicle battery be disconnected, the system memorises the last set position of the alarm. If the alarm
was disarmed, reconnection does not cause the alarm to sound. If the battery was disconnected whilst armed,
reconnection will cause the system to trigger. To cancel, disarm with the remote control. (Vehicle battery
disconnection will cause the optional battery back-up siren to sound - this is turned off at the siren with the special
key provided)
6