Mongoose M33 Owner's Operation Manual

Mongoose M33 Owner's Operation Manual

Car alarm system

Advertisement

M33
Model number:
CAR ALARM SYSTEM
Owner's Operation Manual
Please read and try out all the features
For correct operation and warranty compliance,
we recommend professional installation of this
product by your authorised Mongoose dealer.
Suitable for 12volt, negative ground vehicles
Amended June 2015

Advertisement

Table of Contents
loading

Summary of Contents for Mongoose M33

  • Page 1 CAR ALARM SYSTEM Owner’s Operation Manual Please read and try out all the features For correct operation and warranty compliance, we recommend professional installation of this product by your authorised Mongoose dealer. Suitable for 12volt, negative ground vehicles Amended June 2015...
  • Page 2 ALARM REMOTE CONTROL – 2 supplied BUTTON 1 BUTTON 2 ONLY ‘ARM’ (& LOCK) ‘DISARM’ (& UNLOCK) PRESS FOR 1.5 SECONDS PRESS BUTTON TWO TO TO ARM THE SECURITY SYSTEM - DISARM THE ALARM SYSTEM. (DOORS WILL ALSO LOCK IF THE (DOORS WILL ALSO UNLOCK CENTRAL LOCKING HAS BEEN IF THE CENTRAL LOCKING...
  • Page 3: Table Of Contents

    CONTENTS Arming the system……………………. Indicator flash confirmation codes…..7 Silent arming…………………………… Siren chirp sounds……..……..……..…. 7 Defective zone bypass.……………….. LED flash codes………………………… 7 Disarming the system…………………. EMERGENCY OVERRIDE……………. 8 Security re-arm....…………….. 4 Valet mode (security system disable)… 8 Engine immobiliser…………………….. 4 Automatic arming………………………..
  • Page 4: Arming The System

    OPERATING YOUR VEHICLE SECURITY SYSTEM ARMING (& LOCKING*) Arm the system (and lock the doors*) by pressing button 1 on the remote control. The indicators will flash once and the siren chirps once to indicate that the system is fully armed. The dash mounted LED will light for 10 seconds as the security system checks vehicle integrity and then slow flashes to indicate armed mode.
  • Page 5: Auto Re-Set

    Certain vehicles may require additional extra cost parts to enable the correct use of this feature. CODE HOPPING REMOTE CONTROLS 2 water resistant remote controls are supplied with the M33. Maximum 3 remotes can be used. This coding system is completely random therefore eliminating the possibility of recording it (code grabbing).
  • Page 6: Panic

    BOOT RELEASE BY REMOTE If you vehicle is equipped with electric release of the boot, it can be connected to this alarm system. This may incur additional charges. Disarm the alarm and then press buttons 1 & 2 at the same time to open the boot. PANIC In the event of personal attack, the alarm can be ‘panicked’...
  • Page 7: Indicator Flash Confirmation Codes

    INDICATOR LIGHT FLASH CONFIRMATION / CODES This is a visual indication of system status. A) 1 Flash - Armed B) 2 Flash - Disarmed C) On for 30 sec’ - Indicates system is disarmed and provides perimeter illumination SIREN CHIRP CODES This is an audible indication of system status.
  • Page 8: Emergency Override

    EMERGENCY OVERRIDE At the time of installation a hidden push button switch was fitted, usually under the dashboard. If the alarm is armed and fails to respond to the remote control, or you have misplaced it, you can override the alarm as follows;...
  • Page 9: Code Learning

    REMOTE CONTROL CODE LEARNING • If you need to replace a remote control, it must be memorised to the alarm system before it can be used. • A power surge or interruption to the power supply may cause loss of memory. •...
  • Page 10: Programmable Options

    Jumper on side of module – 2 stage unlock – see page 8 Open = Drivers door unlocks on 1 press – press again to unlock passenger doors Closed = All doors unlock at the same time Amendment to M33 Owner’s operator manual – June 2015...
  • Page 11: Wiring Diagram

    ENGINE IMMOBILISER RELAY 5 16 11 Green Lock common +12V GREY WIRE Bottom Row IGN/ACC 6 17 OF M33 12 Brown/white (+) Siren output 13 Black (-) Ground 7 18 14 No connection 15 Red/white (-) Boot trigger input INT ERUPTED 8 19 IGN’...
  • Page 12: Warranty Terms And Conditions

    Warranty for the installation is borne by the original installing agent only. This will be chargeable if not returned to the original installer. Whilst every care is taken by our installers in fitting the alarm, Mongoose takes no responsibility for any damage caused to a vehicle in the installation process.
  • Page 13: Proof Of Purchase

    Please complete the above details, detach from this manual and keep in a safe place. These details should be presented to your Mongoose dealer in the unlikely event that you require this product to be repaired under the terms of the ‘product warranty’.
  • Page 14 Manufactured for: Mongoose (Australia) Pty Ltd Make & Model Number: Mongoose M33 Series Country of manufacture: China Supply voltage: 12v DC nominal – negative ground Current consumption: 0.3amps Suitability: All vehicles with 12v negative earth batteries Date of manufacture: Refer date code on alarm module case...

Table of Contents