Automatic Re-Set; Arm Condition Memory - Mongoose M80II Upgrade Manual

AUTOMATIC RE-SET

Upon an intrusion (ie. door opened and closed), the siren will sound for 30 seconds, after which it
will stop and reset to the armed position. It will then re-trigger on the next intrusion.
If a door is left open, the siren will sound for 3 x 30 seconds and then that individual circuit will be
bypassed to avoid unnecessary noise. Other circuits remained armed.

ARM CONDITION MEMORY

Should the vehicle battery be disconnected, the system memorises the last set position of the
alarm. If the alarm was disarmed and the siren turned off prior to battery disconnection,
reconnection does not cause the alarm to sound. If the battery was disconnected whilst the system
was armed, reconnection will return the system to the armed state. (See 'battery back-up siren')
NOISE POLLUTION CONTROL
To reduce noise nuisance and possible false alarms, the system will isolate an individual circuit if it
is triggered more than three times or is left open.
Eg: 3 x bonnet, 3 x boot, 3 x doors, 3 x ignition, 3 x impact sensor, (3 x other sensors if fitted)
Reset by remote by disarming and then re-arming. Turn ignition ON/OFF will re-set LED intrusion
codes.
PERIMETER NITE-LITE
Upon unlocking (disarming), the indicators will stay permanently lit for 15 seconds to provide
perimeter illumination.
Ask the installer to verify that the power consumption of all the indicators is within the tolerance of
this products maximum 6 amps per side.
Connecting a trailer may cause may affect the operation of this feature.
8