Silent Arm/Disarm; Automatic Re-Set - Mongoose M60i Owner's Operation Manual

OPEN CIRCUIT BYPASS
If any door, the bonnet or boot is left open upon arming, the siren will chirp once as normal and then
sound briefly to inform you a circuit is still open. If ignored, that circuit will not be protected.
The open circuit (a door, the bonnet or boot) will automatically arm upon closure.
INTRUSION ALERT
When disarming, if the siren chirps 4 times and the indicators flash 3 times you know the system
has been triggered. Refer to the LED flash codes on page 10 to show which circuit has been
triggered.

AUTOMATIC RE-SET

Upon an intrusion, the siren will sound for 30 seconds, after which it will stop and reset to the armed
position. It will then re-trigger on the next intrusion or, for example, if a door is left open.
If a door is left open, the siren will sound for 3 x 30 seconds and then that circuit will be bypassed.
NOISE POLLUTION CONTROL
To reduce noise nuisance and possible false alarms, the system will isolate an individual circuit if it
is triggered three times in succession or is left open. (Eg: 3 x bonnet/boot, 3 x doors, 3 x ignition, 3
x sensor). Reset by remote by disarming and then re-arming, or by turning the ignition 'on' then 'off'.
CENTRAL LOCKING
- additional parts, at extra cost, may be required depending on vehicle equipment level.
This security system has built-in relays to operate a vehicles' existing central locking system by
remote control. When connected, the doors will lock or unlock at the same time as arming or
disarming.
SILENT ARM / DISARM (no siren chirps – alarm models only)
If there is occasion when you don't want the siren to chirp for either arm or disarm, press button two
then button one within 2 seconds. The chirps may be permanently turned off via the programming
options.
7