Table of Contents
Advertisement
M80 Series
M80i, M80S, M80GNZ, M80G
MODELS:
USER OPERATION MANUAL
All models certified to AS/NZS4601 1999 amendment 1
M80S certified to AS/NZS3749.1 2003 Class B
M80G/GNZ certified to AS/NZS3749.1 2003 Class A
These products should be installed according to the requirements of the
AS/NZS 3749.2 Installation Standard.
Installation should only be carried out by suitably qualified persons.
References to alarm functions and siren/horn responses do not apply to model M80i.
Advertisement
Table of Contents
Related Manuals for Mongoose M80i
Summary of Contents for Mongoose M80i
- Page 1 M80G/GNZ certified to AS/NZS3749.1 2003 Class A These products should be installed according to the requirements of the AS/NZS 3749.2 Installation Standard. Installation should only be carried out by suitably qualified persons. References to alarm functions and siren/horn responses do not apply to model M80i.
-
Page 2: Remote Control
BUILT-IN TURBO TIMER ON/OFF. THIS SEQUENCE WILL SILENTLY See page 7 ARM OR DIS-ARM THE ALARM – NO SIREN CHIRPS BATTERY REPLACEMENT CR2032 LITHIUM BATTERIES ARE AVAILABLE FROM YOUR MONGOOSE AGENT OR USUAL BATTERY OUTLET. PLEASE CHANGE ANNUALLY OR IF OPERATION BECOMES INTERMITTENT. -
Page 3: Table Of Contents
Silent arm/disarm ……………….… Boot release…………..…..Bonnet, boot & doors……………… Programme options..….... 13/14 Built-in turbo timer…………………. Remote controls……….... 2 stage impact sensor (excl’ M80i) Remote code learning....14/15 Glass break sensor……………….. EMERGENCY OVERRIDE…… 16 Sensor disable...……………..PIN code programming…….…. Intrusion alert ……………….…….. -
Page 4: Automatic Engine Immobilisation
OPERATING YOUR VEHICLE SECURITY SYSTEM AUTOMATIC ‘TRIPLE CIRCUIT’ ENGINE IMMOBILISATION The engine always immobilises automatically 30 seconds after the ignition has been turned off. When you turn the ignition OFF, the dashboard LED will start to fast flash for 30 seconds to indicate the automatic sequence has commenced. -
Page 5: Arming
ARMING NORMAL OPERATION Exit the vehicle and ensure all doors, bonnet & boot are closed. Press remote button one for approximately 1 second (2+ seconds if turbo timer on). To confirm arming, the indicators flash once, the siren chirps once and the dashboard warning LED, will then slow flash. -
Page 6: Disarming
DISARMING Press button one on the remote control to disarm the system. The siren will chirp twice and the indicators will flash twice to confirm disarm. The doors will unlock if the vehicles’ central locking is connected to the security system. ... -
Page 7: Built-In Turbo Timer
BUILT-IN TURBO TIMER The built-in turbo timer allows the engine to continue running (if installed for this feature) for a pre- programmed time after the ignition has been turned off. This feature may be used to allow the vehicles turbo/engine to cool down. In normal driving situations and to save fuel, the turbo timer should not be necessary. -
Page 8: Glass Break Sensor
This sensor is designed to trigger the alarm by detecting the sound of actual glass breakage. The sensitivity level is set by the installer and should be at its optimum. SENSOR DISABLE BY REMOTE (EXCEPT M80i) There are times when you may wish to deactivate sensors, such as the impact sensor, to prevent false alarms. -
Page 9: Optional Extras
OPTIONAL ACCESSORIES GPS TRACKING Mongoose can provide various GPS tracking options whether it is to recover a stolen vehicle or for vehicle and people management. Mongoose offers models that are completely controlled and monitored by an iPhone or similar, or via our GPRS website, provide data and route logging with full reporting options. -
Page 10: Battery Back-Up Siren (M80S/G)
BATTERY BACK-UP SIREN (M80S/G/GNZ) These models have a battery back-up siren. Vehicle battery disconnection will cause the battery back-up siren to sound. The siren can be turned off with the special keys provided. The siren is mounted under the bonnet and should be situated in a place to protect it from heat and water damage. -
Page 11: Indicator Flashing
INDICATOR FLASHING When the siren sounds, the indicators flash simultaneously. The indicators will also flash on arming and disarming the system. 1 Flash - Armed. 2 Flash - Disarmed. 3 Flash - Disarmed and previously triggered. On permanently – Open circuit after arming, or Perimeter Nite Lite is on DASH MOUNTED LED WARNING LIGHT The LED shows the status of the alarm, intrusion and any open circuit when arming. -
Page 12: Car Finder & Panic
PANIC BY REMOTE (in either armed or disarmed state) In the event of personal attack, or you suspect that your vehicle is being tampered with, the alarm can be ‘panicked’ by pressing buttons one and two at the same time on the remote for more than 3 seconds. -
Page 13: Programme Options
PROGRAMMABLE OPTIONS These should only be changed by your installer. AUTOMATIC (LAST DOOR) ARMING (default = OFF) – also OFF when turbo timer is on When programmed ON, the alarm will arm automatically 30 seconds after the last door is closed. ... -
Page 14: Remote Code Learning
NSW SIREN TIMING ( default = OFF It is a mandatory requirement in New South Wales, Australia, for vehicle alarm systems to sound the siren for one cycle of 30 seconds only before it is re-set manually by remote control. With this feature turned on, the indicators will flash for any subsequent trigger. -
Page 15: Remote Controls
An irregular or interruption to the vehicle’s power supply may cause loss of remote memory. If your alarm fails to respond to the remote try re-learning them, or see your Mongoose dealer. - Page 16 The siren will chirp 3 times, the indicators will flash 3 times to confirm you have entered remote code learning mode. (no chirps on M80i unless siren/horn connected) Press button one on the first remote – siren will chirp once as confirmation of reception ...
-
Page 17: Emergency Override
EMERGENCY OVERRIDE – 4 DIGIT PIN CODED EMERGENCY 4 DIGIT PIN CODE OVERRIDE If all remotes are lost or inoperable, the system can be disarmed by PIN CODE: entering your the unique 4 digit PIN code issued with this product. PLEASE KEEP THIS CARD IN A SAFE PLACE KEEP THE CARD IN A SAFE PLACE –... - Page 18 OVERRIDE PIN CODE PROGRAMMING Your security system is pre-programmed with a unique 4 digit PIN code as shown on the ‘PIN code card’. You may wish to have your own code programmed to a number that is easier to remember. Once changed, the factory setting is permanently erased.
-
Page 19: Testing Your Alarm
1) Without disarming the system, unlock and open a door with the ignition key - the alarm should sound, excluding model M80i. Check all other doors, bonnet and boot by the same procedure. 2) Check the impact sensor, M80S/G, by giving the vehicle varying degrees of impact - be careful to do this on areas of the vehicle not likely to be damaged by impact. - Page 20 WIRING INFORMATION: Installation to be carried out by suitably qualified persons. MAIN MODULE The wires printed for the function; (+) INDICATOR – 8 amp FUSED 1) ORANGE – UNLOCK – NO FUSED (+) 12V FUSED 2) BLUE – UNLOCK – COMMON (+) INDICATOR –...
- Page 21 WIRING - use immobiliser circuit #1 for turbo timer See next page for built-in turbo timer wiring.
- Page 22 SIREN / BONNET BATTERY BACK-UP POWER TRIGGER BONNET BONNET STANDARD TRIGGER BONNET BONNET BUILT-IN TURBO TIMER WIRING Must use immobiliser circuit # 1 for ignition Ignition barrel Ignition sense wire CUT ignition wire Immobiliser circuit #1 +12v permanent Use immobiliser circuits #2 & #3 for other circuits...
- Page 23 CENTRAL LOCKING CONNECTION OPTIONS POSITIVE OR NEGATIVE SWITCHING REVERSE POLARITY +12 VOLTS (insert fuses if none supplied) PURPLE - LOCK PURPLE - LOCK WHITE - LOCK TO CAR WHITE - LOCK GREEN - LOCK LOCK GREEN - LOCK TO DOOR ORANGE - UNLOCK ORANGE - UNLOCK BROWN - UNLOCK...
- Page 24 PROGRAMME OPTIONS (no chirps for M80i unless siren/horn connected) Ensure the drivers door is open Within 15 seconds of opening the door, turn the ignition ON/OFF the number of times relative to the programme chart (eg: 4 times for ignition door lock).
-
Page 25: Warranty Conditions
(a) the defect has been notified as soon as it is noticed to an authorised Mongoose installation centre, distributor or agent (in the first instance to the original installation centre). - Page 26 Whilst this security system provides a deterrent, it may not prevent theft or damage through wilful criminal intent. Mongoose does not by inference, intent or any other means guarantee that a vehicle fitted with one of it’s security systems will not be stolen, broken into, tampered with, or parts taken.
-
Page 27: Proof Of Purchase
Please complete the above details, detach from this manual and keep in a safe place. These details should be presented to your Mongoose dealer in the unlikely event that you require this product to be repaired under the terms of the ‘product warranty’. Refer ‘Warranty Conditions’. Failure to provide this ‘Proof of Purchase’... - Page 28 www.mongoose.co.nz...
Need help?
Do you have a question about the M80i and is the answer not in the manual?
Questions and answers