Eliminating The Arm / Disarm Chirps - Mongoose M8 Owner's Operation & Installation Manual

...
Enter the vehicle and observe the dash mounted LED it will flash a code.
If the LED is flashing one time... pause...one time... etc., then the alarm was triggered via the shock sensor.
If the LED is flashing two times...pause. ..two times...etc., then the alarm was triggered via the bonnet or
boot ....or an optional sensor, such as a glass break sensor, has been connected to one of these circuits.
If the LED is flashing three times...pause...three times...etc., then an intrusion attempt was made through
one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory and will only be erased from memory
when the ignition key is turned on.

ELIMINATING THE ARM / DISARM CHIRPS:

The normal arming and disarming confirmation "chirps" can easily be turned on and off using the valet push
button switch.
To do this:
Turn the ignition key on, and then off.
Within 10 seconds of turning the ignition key off, press and release the LED valet push button switch three
times.
If the chirps were on, then you will hear 2 chirps to indicate that the chirps have been turned off.
If the chirps were off, then you will hear 1 chirp to indicate that the chirps have been turned on.
NOTE:
Whenever the chirps are by-passed, the defect and intrusion chirps will always operate.