Oil Pump Inspection; Oil Pump Installation - Honda MB5 1982 Shop Manual

LUBRICATION
OIL PUMP INSPECTION
Remove the oil pump and inspect the following
items:
Damaded or weakened 0-rings.
Damage to crankcase mating face.
Damage to pump body.
Improper oil control lever.
CAUTION
I
Do not disassemble the oil pump.
OIL PUMP INSTALLATION
Install the oil pump to the crankcase aligning the
groove in the pump drive shaft with the lug on the
oil pump.
NOTE
• Lubricate the 0-ring with clean grease
before installation.
Make sure that the oil pump is inserted
into the crankcase properly.
Tighten the oil pump attaching bolts securely.
Reconnect the oil pump control cable.
Reinstall the oil pipe and oil pass tube.
NOTE
Perform the following inspections and adjust-
ments:
Control cable adjustment (Page 3-6).
Oil pump air bleeding (Page 2-7).
Oil pass tube air bleeding (Page 2-7) .
Oil leaks.
2-6
MATING FACE
18
~HONDA
~
MB5
CONTROL LEVER
0-RING
OIL PUMP
CONTROL CABLE
Date of Issue : July, 1981
©
HONDA MOTOR CO., L TO.