Table of Contents
Advertisement
HYDRAULIC
BRAKE
Install the pad spring, pads and shims with the pin
bolts.
NOTE
If the brake pad is dirty. clean with
sand
paper.
Loosely
install the pin bolts.
Make sure
that the
pin bolts are inserted through
the holes
in the brake
pad and
shim.
INSTALLATION
Install
the bracket to the caliper.
Install
and tighten the cal
iper
to
the front fork to
the specified torque.
TORQUE: 24-30 N·m (2.4-3.0 kg·m,
17-22
ft-lb)
Tighten
the bracket bolts
to the specified torque.
TORQUE:
20-25
N·m (2.0-2.5 kg·m,
14-18 ft·lb)
Tighten
the pin bolts
and
secure
with the lock
washer.
TORQUE: 15-20 N·m (1.5-2.0 kg·m,
11
-
14ft-lb)
After
the
front
brake
has
been
installed, bleed air
·
from
the system (Page
12·2).
BRAKE MASTER CYLINDER
REMOVAL
Drain
brake fluid from the bleeder valve
by operat·
ing the brake lever.
Remove the brake lever, front stoplight
switch, rear
view mirror and brake hose.
Remove the master cylinder from the
handlebar.
12-8
SHIM
PADS
SHIM
20-25 N·m
(2.0-2.5 kg-m, 14-18
ft-lb)
MASTER CYLINDER
\
142
~HONDA
~
MB5
LOC
WASHER
PIN BOLTS
24-30
N-m
(2.4-3.0 kg-m, 17-22 ft-lb)
Date of
Issue:
July, 1981
©HONDA
MOTOR
CO.,
LTD.
Advertisement
Table of Contents
Troubleshooting
