Transmission Oil Level Check; Transmission Oil Level Change - Honda MB5 1982 Shop Manual

~HONDA
~
MBS
TRANSMISSION OIL
OIL LEVEL CHECK
Before checking the oil level run the engine and
allow to idle for a few minutes.
Support the motorcycle upright on level ground.
Stop the engine and remove the oil level check bolt
from the right crankcase cover.
A small amount of oil should flow out of the oil
level bolt hole.
OIL CHANGE
Warm the engine to normal operating temperature.
Remove the oil filler cap.
Remove the oil drain plug and drain the oil.
Reinstall the drain plug.
TORQUE: 20-25 N·m (2.0-2.5 kg·m,
14-18 ft-lb)
CAUTION
Make sure that the sealing washer on the drain
plug is in good condition.
Refill the engine up to the proper level.
OIL CAPACITY: 0.91it (1.0 US qt) at change
SPECIFIED OIL: 10W-40 or equivalent
Start the engine and check for leaks. Stop the
engine and recheck the oil level.
Date of Issue: July, 1981
© HONDA MOTOR CO., L TO.
LUBRICATION
OIL LEVEL CHECK BOLT
OIL FILLER CAP
DRAIN PLUG
20-25 N·m (2.0-2.5 kg-m, 14-18 ft-lb)
15
2-3