Brake Disc Inspection - Honda MB5 1982 Shop Manual

HYDRAULIC BRAKE
Push the piston all the way in to allow installation
of new brake pads.
Remove the two pin bolts, then the brake pads and
shims.
Clean the brake caliper.
Install the shims, brake pads, pad spring and lock
washer and loosely install the pin bolts.
CAUTION
• Do not reuse the old lock washer.
Replace both pads as a set. Do not replace
one without replacing another.
Install the shim on the back of the pad.
Ensure that the pin bolts are inserted throuth the
holes in the brake pads.
Install the caliper on the fork leg.
TORQUE: 24-30 N·m (2.4-3.0 kg·m,
17-22 ft-lb)
Tighten the pin bolts to the specified torque and
bend the tabs of the lock washer against the side
of each bolt.
TORQUE: 15-20 N-m (1.5-2.0 kg-m,
11-14ft-lb)
BRAKE DISC INSPECTION
Measure the brake disc thickness.
SERVICE LIMIT: 3.0 mm (0.12 in)
12-4
138
PAD
SPRING
~HONDA
~
MB5
PIN BOLTS
SHIM
PADS SHIM
Date of Issue: July, 1981
© HONDA MOTOR CO., L TO.