Rts Line State; Beep On <Bel - Motorola LI2208 Product Reference Manual

4 - 16 LI2208 Product Reference Guide

RTS Line State

This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or
High RTS line state.
*
Host: Low RTS
Beep on <BEL>
Point-to-Point Mode Only
When this parameter is enabled, the linear imager issues a beep when a <BEL> character is detected on the
RS-232 serial line. <BEL> is issued to gain a user's attention to an illegal entry or other important event.
NOTE This parameter is not supported in Multipoint-to-Point mode.
Beep On <BEL> Character
(Enable)
Host: High RTS
*
Do Not Beep On <BEL> Character
(Disable)