Rts Line State; Beep On <Bel; Point-To-Point Mode Only - Motorola Symbol DS3578 Product Reference Manual

RTS Line State

This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or High
RTS line state.
Beep on <BEL>

Point-to-Point Mode Only

When this parameter is enabled, the scanner issues a beep when a <BEL> character is detected on the RS-232
serial line. <BEL> is issued to indicate an illegal entry or other important event.
NOTE This parameter is not supported in Multipoint-to-Point Mode.
*
Host: Low RTS
Host: High RTS
Beep On <BEL> Character
(Enable)
*
Do Not Beep On <BEL> Character
(Disable)
RS-232 Interface 7 - 17