SiEN12-710A
2.15 Care and cleaning
FTKS 25/35 D, FTXS 25/35 E
CAUTION
Before cleaning, be sure to stop the operation and turn the breaker OFF.
UNITS
" Indoor unit, Outdoor unit and Remote control
1.Wipe them with dry soft cloth.
" Front panel
1. Open the front panel.
2. Remove the front panel.
3. Clean the front panel
4. Attach the front panel.
CAUTION
•
Don't touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
•
When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
•
When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
•
For cleaning, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing compound,
scrubbing brushes, nor other hand stuff.
•
After cleaning, make sure that the front panel is securely fixed.
Operation Manual
•
Hold the panel by the tabs on the two sides
and lift it until it stops with a click.
•
Lift the front panel up, slide it slightly to the
right, and remove it from the horizontal axle.
•
Wipe it with a soft cloth soaked in water.
•
Only neutral detergent may be used.
•
In case of washing the front panel with water,
dry it with cloth, dry it up in the shade after
washing.
•
Set the 2 keys of the front panel into the slots
and push them in all the way.
•
Close the panel slowly and push the panel at
the 3 points.
(1 on each side and 1 in the middle)
Fit the key
into the slot.
Instruction
89