Air Filter - Daikin F-Series Service Manual

Inverter multi f-series
Hide thumbs Also See for F-Series:
Table of Contents

Advertisement

Instruction
FILTERS
1. Open the front panel.
2. Pull out the air filters.
3. Take off the Titanium Apatite Photocatalytic
4. Clean or replace each filter
5. Set the air filter and Titanium Apatite

" Air Filter

1. Wash the air filters with water or clean them
" Titanium Apatite Photocatalytic Air-Purifying Filter
The Titanium Apatite Photocatalytic Air-Purifying Filter can be renewed by washing it with water once
every 6 months. We recommend replacing it once every 3 years.
[Maintenance]
1. Remove dust with a vacuum cleaner and wash lightly with water.
2. If it is very dirty, soak it for 10 to 15 minutes in water mixed with a neutral cleaning
3. Do not remove filter from frame when washing with water.
4. After washing, shake off remaining water and dry in the shade.
5. Since the material is made out of paper, do not wring out the filter when removing
[Replacement]
1. Remove the tabs on the filter frame and replace with a new filter.
90
Push a little upwards the tab at the center of
each air filter, then pull it down.
Air-Purifying Filter .
Hold the recessed parts of the frame and
unhook the four claws.
See figure.
Photocatalytic Air-Purifying Filter as they
were and close the front panel.
Insert claws of the filters into slots of the front
panel. Close the front panel slowly and push
the panel at the 3 points. (1 on each side and
1 in the middle.)
with vacuum cleaner.
If the dust does not come off easily, wash
them with neutral detergent thinned with
lukewarm water, then dry them up in the
shade.
It is recommended to clean the air filters
every two weeks.
agent.
water from it..
Dispose of the old filter as flammable waste.
Titanium Apatite
Photocatalytic
Air-Purifying Filter
Filter frame
Tab
Push
Tab
Operation Manual
SiEN12-710A
Air filter

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents