To Set The Clock - Daikin F-Series Service Manual

Instruction

" To set the clock

1. Press "CLOCK button".
2. Press "TIMER setting button" to set the
3. Press "CLOCK button".
" Turn the breaker ON
•
NOTE
" Tips for saving energy
• Be careful not to cool (heat) the room too much. Keeping the temperature setting at a
moderate level helps save energy.
• Cover windows with a blind or a curtain. Blocking sunlight and air from outdoors
increases the cooling (heating) effect.
• Clogged air filters cause inefficient operation and waste energy. Clean them once in about every two weeks.
" Please note
• The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
• If you are not going to use the air conditioner for a long period, for example in spring or autumn, turn the breaker OFF.
• Use the air conditioner in the following conditions.
Mode
COOL
HEAT
DRY
• Operation outside this humidity or temperature range may cause a safety device to disable the system.
72
0:00 is displayed.
blinks.
clock to the present time.
Holding down " " or "
increases or decreases the time display.
: blinks.
Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
Operating conditions
Outdoor temperature: 10 to 46°C
Indoor temperature: 18 to 32°C
Indoor humidity: 80% max.
Outdoor temperature: –10 to 20°C
Indoor temperature: 10 to 30°C
Outdoor temperature: 10 to 46°C
Indoor temperature: 18 to 32°C
Indoor humidity: 80% max.
" button rapidly
POWERFUL
If operation is continued out of this range
• A safety device may work to stop the
operation.(In multi system, it may work to stop
the operation of the outdoor unit only.)
• Condensation may occur on the indoor unit and
drip.
• A safety device may work to stop the operation.
• A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and
drip.
ECONO
ON/OFF
TEMP
MODE FAN SWING
QUIET MOLD PROOF SENSOR
ON CANCEL
OFF
TIMER
Recommended temperature setting
For cooling:26°C – 28°C
For heating:20°C – 24°C
Operation Manual
SiEN12-710A
2
1, 3