Removing The Engine Guard (Exc-F Wess Eu, All Six Days Models, Xcf-W); Installing The Engine Guard (Exc-F Wess Eu, All Six Days Models, Xcf-W) - KTM 350 EXC-F WESS Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.47
12.48
102
E00339-10
Removing the engine guard (EXC‑F WESS EU, All Six Days models, XCF‑W)
H01638-10
Installing the engine guard (EXC‑F WESS EU, All Six Days models, XCF‑W)
H01638-10
–
Now inject fluid into the system until it escapes from the
6
opening of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Remove the bleeding syringe. Mount and tighten the bleeder
screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Immediately clean up any brake fluid that has over-
flowed or spilled with water.
–
1
Remove screws and engine guard.
–
Attach the engine guard on the frame at the rear and swing up
at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
4 mm (0.16 in)
1
.
M6 10 Nm (7.4 lbf ft)