Programming The Weekend Timer - Olivieri ERGOFLAM IDRO Installation Instructions Manual

After having set the time-schedule intervals, in order to activate the
programming it is essential to proceed to enable it (operation of the
weekly led being lit).
Press the TIMERTHERMOSTAT/ESC button to exit the weekly timer menu at any
time without saving the changes made.
i Scrolling through the minutes is done in the same way as described in the
daily programming.

Programming the Weekend Timer:

Press the MENU button, scroll through the various menus by means of the power
regulating buttons and finally access the timer menu by pressing the SET button.
From the timer menu enter modify mode by pressing the SET button, display the
message "FiSe" and press the SET button again. Now the weekly led is lit on the
right of the control panel. Press SET again to change the ON/OFF intervals.
i For the days from Monday to Friday three time-schedule programming
bands are available and the same number of bands for Saturday and
Sunday. To scroll through the various parameters (preselected intervals of
days, programming band and on/off time-schedule) use the power
regulating buttons.
At this stage there appears on the top display a broken line or alternatively the
preset time, while on the left of the bottom one there appears the number of the
time-schedule band selected and in the right-hand part two characters that
indicate the days from Monday to Friday (LU) or those from Saturday to Sunday
(SD).
The lamp led indicates that a heater on time-schedule is being changed, while
the screw led indicates that an off time-schedule is being changed.
Now enable the
LIGHTING/UNLOCKING button.
pre-selected time-schedule band by pressing
Page | 56
the