Programming The Weekly Timer - Olivieri ERGOFLAM IDRO Installation Instructions Manual

Programming the Weekly Timer:

Press the MENU button, scroll through the various menus by means of the power
regulating buttons and finally access the timer menu by pressing the SET button.
By means of the POWER + and POWER - buttons, display the message "sett" and
press the SET button again. Now the weekly led is lit on the right of the control
panel.
i Within the same week there are 3 different time-schedule programming
bands available. To scroll through the various parameters (programming
band and on time-schedule) use the power regulating buttons.
At this stage there appears on the top display a broken line or alternatively the
time set, while on the left of the bottom one there appears the number of the
time-schedule band and in the right-hand part a fixed character that indicates
the days from Monday to Sunday "Ld".
When the lamp led is lit on it indicates that a heater on time-schedule is being
changed, while when the screw led is lit it indicates that an off time-schedule is
being changed.
Now enable the
LIGHTING/UNLOCKING button.
The top display now shows the time-schedule on 00:00 and on the value
previously set. Press the SET button to access the modify mode and use the
POWER + and POWER - buttons to choose to change the hours or the minutes.
Changing these values is done by pressing the TEMPERATURE + and TEMPERATURE
- buttons.
In order to save the settings, press the SET button.
Now you can
TIMERTHERMOSTAT/ESC button for several seconds, approximately 4, until the
daily led is lit. Now repeat this operation to light the weekly led.
In order to complete the programming it is necessary for at least one
programming band (1, 2 or 3) to have its on time and its off time set, that
will indicate the moments for the product to be lit and extinguished.
pre-selected time-schedule
proceed to enable
band by
the programming.
pressing the
Press the
Page | 55