Safety Devices - Olivieri ERGOFLAM IDRO Installation Instructions Manual

3.4

Safety devices

The heater is fitted with some safety devices, such as:
The fume temperature detector probe: This device allows the fume
temperature to be read and the effective operation of the product to be
monitored continuously;
The pellet tank temperature detector probe: It detects the tank
temperature continuously and causes product operation to be locked if a
certain safety limit value is exceeded;
A pressure switch . This enables any obstruction of the flue to be detected;
The encoder: This enables non-programmed variations in the number of
operating turns of the fume extractor or its sudden stoppage to be
detected;
An ambient probe: This probe enables the temperature in the room where
the heater is installed to be constantly monitored;
A Pellets thermostat: This detects overtemperature of the pellets tank.
It is forbidden to fail to install or to remove one of the above-mentioned
safety devices; if these must be temporarily deactivated or disconnected
for maintenance work, they must be reinstalled in order to turn the product
on again.
The action of one or these devices causes an error message to be shown
on the display.
When the messages "Alt", that indicates the occurrence of an error, and
"Spe", that indicates the heater has been extinguished, appear on the
display, a malfunction has occurred.
Possible error messages displayed are shown in the table on the next
page.
Page | 50