Table of Contents
Advertisement
During the check-up, errors may be indicated that prevent the heater starting up
(point 3.4).
i
For lighting on subsequent occasions, point 5 need not be performed.
Extinguishing the product:
1. Press the ON/OFF button for several seconds.
The heater will initiate the extinguishing procedure according to the methods set
during the design stage (the extinguishing time is variable and may go from a
minimum of a few minutes up to around 35 minutes).
We recommend that you do not stop the extinguishing procedure before it
has been completed in full, for example by cutting power to the product.
Precaution: if the flame is out because there are no pellets, proceed to
extinguish the heater. Only when the heater is in OFF condition should you
proceed to load further fuel inside the tank to start the new lighting
procedure.
Pellets must not be inserted into the pan by hand.
Use the stove always with the door closed. It is only allowed to be open to
perform maintenance work to the product when cold.
i
The firebox must not be changed.
Tampering with the apparatus, as well as use of spares that are not
original, and unauthorised replacement of parts of the product, besides
invalidating the guarantee, may cause malfunctions and serious danger
to the safety of the users who are in direct contact with the product.
During use, do not obstruct the vent openings, that allow the combustion
air to recirculate continuously, and the air intake located at the rear of the
product.
Page | 46
Hide quick links:
Advertisement
Table of Contents
