Control Panel; Ergoflam Air - Olivieri ERGOFLAM IDRO Installation Instructions Manual

3.1

Control panel

ERGOFLAM AIR

BUTTONS
No. FUNCTION
1 ON/OFF
UNLOCKING
ENABLING
2 MENU
3 POWER + (*)
4 POWER - (*)
5 TEMPERATURE
+ (**)
6 TEMPERATURE
- (**)
7 TIMER-
THERMOSTAT
ESC
8 SET
LED
DESCRIPTION
Pressed for around three seconds it allows the heater to be lit and
extinguished.
Kept pressed it permits the heater to be unlocked and subsequently
turned off (Errors in operation may cause the heater to lock).
Enabling of the timer-thermostat programmings within the timer
menu.
Allows access to the menu mode at any time, regardless of the
condition of the heater.
Increases the operating power level (from 1 to 5) In menu mode it
allows scrolling through menus and submenus.
Decreases the operating power level (from 5 to 1) In menu mode it
allows scrolling through menus and submenus.
Increases the ambient thermostat setting value from a minimum of
15ºC to a maximum of 30ºC. In modify mode within menus it allows
the values of the degrees chosen to be varied.
Decreases the ambient thermostat setting value from a maximum of
30ºC to a minimum of 15ºC. In modify mode within menus it allows
the values of the degrees chosen to be varied.
Enables the timer-thermostat and selects the programming method
when pressed for three seconds until the audible signal sounds.
Allows exit from a menu or a submenu.
In menu mode it enables the parameters to be changed and
permits the new settings to be saved. It permits the display of:
G01 Fume temperature [ºC]
G02 Ambient temperature [ºC]
G03 Fume extractor speed [rpm]
dr Software version
Page | 41