Communication Connections; 10/100Baset(X) Ethernet Port Connection - Moxa Technologies AWK-1121 Quick Installation Manual

Communication Connections

10/100BaseT(X) Ethernet Port Connection

The 10/100BaseT(X) ports located on the AWK-1121's front panel are
used to connect to Ethernet-enabled devices.
The pinouts for both MDI (NIC-type) ports and MDI-X (HUB/Switch-type)
ports are shown below:
MDI Port Pinouts
Pin
1
2
3
6
RS-232 Connection
The AWK-1121 has one RS-232 (8-pin RJ45) console port located on the
top panel. Use either an RJ45-to-DB9 or RJ45-to-DB25 cable to connect
the Moxa AWK-1121's console port to your PC's COM port. You may then
use a console terminal program to access the AWK-1121 for console
configuration.
Console Pinouts for 10-pin or 8-pin RJ45
10-Pin Description
1
2
3
4
5
6
7
8
9
10
NOTE
1. The pin numbers for DB9 and DB25 male connectors, and
hole numbers for DB9 and DB25 female connectors are
labeled on the connector strip. However, the numbers are
typically quite small, so you may need to use a magnifying
glass to see the numbers clearly.
2. The pin numbers for both the 8-pin and 10-pin RJ45
connectors (and ports) are typically not labeled on the
connector (or port). Refer to the pinout diagram above for
details.
MDI-X Port Pinouts
Signal
Tx+
Tx-
Rx+
Rx-
8-Pin
–
DSR
RTS
GND
TxD
RxD
DCD
CTS
DTR
–
Pin Signal
1
2
3
6
–
1
2
3
4
5
6
7
8
–
- 9 -
8-pin RJ45
Rx+
Rx-
Tx+
Tx-