Danfoss VLT HVAC Basic Drive FC 101 Quick Manual page 30

Quick Guide
Changes Made
Changes Made lists all parameters changed since factory
setting. Only the changed parameters in current edit-setup
are listed in changes made.
If the parameters value is changed back to factory setting's
value from another different value, the parameter will NOT
be listed in Changes Made.
1. Press [Menu] key to enter the Quick Menu until
indicator in display is placed above Quick Menu.
▲ ▼
2.
Press [ ] [ ] to select either FC 101 wizard,
closed loop setup, motor setup or changes made,
then press [OK].
▲ ▼
3.
Press [ ] [ ] to browse through the parameters
in the Quick Menu.
4. Press [OK] to select a parameter.
▲ ▼
5.
Press [ ] [ ] to change the value of a parameter
setting.
6. Press [OK] to accept the change.
7. Press either [Back] twice to enter "Status", or
press [Menu] once to enter "Main Menu".
The Main Menu accesses all parameters.
1. Press [Menu] key until indicator in display is
placed above "Main Menu".
▲ ▼
2.
Press [ ] [ ] to browse through the parameter
groups.
3. Press [Ok] to select a parameter group.
▲ ▼
4.
Press [ ] [ ] to browse through the parameters
in the specific group.
5. Press [Ok] to select the parameter.
▲ ▼
6.
Press [ ] [ ] to set/change the parameter value.
®
VLT HVAC Basic Drive Quick Guide
®
MG18A402 - VLT is a registered Danfoss trademark
1 1
29