TROUBLESHOOTING
Engine does not turn
1. Ignition switch is in the OFF position.
–
Place switch to ON position.
2. Transmission is not set on PARK or NEUTRAL.
–
Set transmission either in PARK or in NEUTRAL or press any brake lever.
3. Burnt fuse.
–
On Traxter CVT , check main fuse condition.
–
On Traxter 5 SPEED , check MPEM and solenoids fuses condition.
4. Weak battery or loose connections.
–
Check charging system fuse.
–
Check connections and terminals condition.
–
Have the battery checked.
–
Contact an authorized Bombardier ATV dealer.
Engine turns over but fails to start
1. Burnt fuse.
–
Check ignition fuse condition.
2. Mixture not rich enough to start cold engine
–
Check fuel tank level and check starting procedure, particularly use of the
choke.
–
NOTE: On Traxter 5 SPEED , below - 15°C (5°F) the use of fuel primer (op-
tional) is required. Also, it is recommended to add gas line antifreeze.
3. Flooded engine (spark plug(s) wet when removed).
–
Refer to SPECIAL PROCEDURES.
4. No fuel to the engine (spark plug(s) dry when removed).
–
Check fuel tank level; turn fuel valve to ON (also try on RES).
–
A failure of the fuel pump or carburetor may have occurred.
–
Contact an authorized Bombardier ATV dealer.
5. Spark plug/ignition (no spark).
–
Check ignition fuse condition.
–
Remove spark plug(s) then reconnect to ignition coil or spark plug caps.
–
Check that ignition switch and/or engine stop switch(es) is/are at the ON
position.
–
Start engine with spark plug(s) grounded to engine away from spark plug
holes. If no spark appears, replace spark plug(s).
–
If trouble persists, contact an authorized Bombardier ATV dealer.
_____________________
131