BOMBARDIER 650 Operator's Manual page 115

Remove oil strainer cover and oil col-
lector, located near drain plug, then
clean oil strainer.
V01C2QY
1. Oil strainer cover
2. Oil plug
3. Coolant plug
All Models
To clean oil strainer, use a solvent then
dry with compressed air.
WARNING
Always wear eye protection and
gloves.
Reinstall oil strainer, oil collector and
oil strainer cover.
Change gasket on drain plug. Clean
gasket area on engine and drain plug
then reinstall plug. Refill engine at the
proper level with the recommended
oil. Refer to SPECIFICATIONS for ca-
pacity.
Start engine and let idle for a few min-
utes. Ensure oil filter area and drain
plug areas are not leaking.
Stop engine. Wait a while to allow oil
to flow down to crankcase then check
oil level. Refill as necessary.
Dispose of oil as per your local envi-
ronmental regulations.
Coolant Replacement
In order to avoid potential burns,
3
do not remove the radiator cap or
loosen the engine drain plug if the
2
engine is hot.
1
Turn the radiator cap counterclockwise
and remove it.
On Traxter CVT , remove the skid plate
under vehicle.
On Traxter 5 SPEED , lift the rear of
vehicle, about 75 mm (3 in).
Remove the drain plug and drain the
coolant into a suitable container.
V04C0AY
TRAXTER CVT — UNDER OIL FILTER COVER
1. Cooling drain plug
NOTE:
completely.
_____________________
WARNING
1
Do not unscrew the drain plug
115