BOMBARDIER 650 Operator's Manual page 80

Turn the ignition switch to the OFF po-
sition.
Insert a little flat screwdriver into the
slot at the bottom of the speedome-
ter. Slightly, pry the speedometer and
turn it clockwise then remove it from
steering pod.
V01A67Y
Plug connectors to change units from
miles to kilometers. Unplug to return
to miles reading.
Reinstall the speedometer into steer-
ing pod and turn it counterclockwise
to lock the speedometer.
Display Selector Button
The odometer always appears when
turning the ignition switch ON (either
ON position). To change the display
to the trip meter, depress the display
selector button.
Depressing display selector button
again will change display for the
hourmeter. Push it again to return
to odometer.
Odometer
Odometer records the total distance
travelled either in miles or kilometers.
Trip Meter
The trip meter records distance trav-
elled since it has been reset. Distance
travelled is displayed either in miles or
kilometers.
It can be used to establish a fuel tank
range or distance between 2 way
points for distance.
Push and HOLD display selection but-
ton for 2 seconds to reset the trip me-
ter.
Hourmeter
The hourmeter records engine running
time in hours and minutes.
Indicator Lamps
High Intensity (BLUE)
AUTO Mode (AMBER)
Engine Temperature (RED)
CAUTION:
turn off after engine starting, stop
engine. See an authorized Bom-
bardier ATV dealer. Do not use the
vehicle until repaired.
_____________________
When this indicator lamp is
ON, it indicates high intensity is
selected on the headlamps.
NOTE: The auxiliary headlamp
functions when high intensity is
selected.
•Traxter 5 SPEED:
When lit, it indicates the vehicle
is operating in autoshift mode.
•Traxter CVT:
When this indicator lamp is
ON, it indicates the engine is
overheating.
•Traxter 5 SPEED:
Dual function light. When
indicator light is ON, it indicates
a low oil pressure condition of
the engine. When flashing,
it indicates the engine is
overheating.
•All:
This light turns on when the
ignition switch is turned on
and remains on until engine is
running.
If engine overheats, refer
to ENGINE OVERHEAT in
SPECIAL PROCEDURES.
If the light does not
79