Esc Link Function "Mclnk - FUTABA 1M23N20718 Instruction Manual

ESC Link Function "MCLNK"

This is a special function which allows Futaba motor controller (MC) data changes to be
set by the T4PK transmitter (MC950CR, MC851C, MC602C, MC02R, etc.).
However, some data changes require a PC and Link software.
This function is used by connecting ESC directly to the transmitter. The T4PKS power
switch is used at the display side. Use the various optional servo extension cords according to
the distance between the transmitter and ESC.
The last data read from ESC to T4PKS or the last data written from T4PKS to ESC is saved
to the T4PKS. Since the data for each model memory can be saved, the data of up to 40 mod-
els can be saved.
-When the T4PKS battery voltage drops, the display switches to low battery display.
Therefore, use this function when there is ample battery capacity remaining.
-Also connect the battery at the ESC side.
Calling the setup screen
*Calling from menu screen
(Opening Screen)
MENU 1
MENU 2
Press t
* When the direc t c all but ton
is set, the setup screen is also
called by the following method:
(Opening Screen)
DIRECT SEL
Press the button set
at this function.
106
Menu screen call
by button
MENU1/2 selection
by button
Select the function
by button
he button
Press t
he button
ESC Link Function "MCLNK"
Cover
MC950CR
Communication port
(interior left side)
ESC receiver connector
Connecting ESC receiver
connector to the transmitter
Communication port
MC402CR
MC602C
MC851C