FUTABA 1M23N20718 Instruction Manual page 89

Set table functions
Abbreviation used on setup screen
PRESET
NT-BRAKE
A.B.S.CH2
A.B.S.CH3,CH4
2ND COND
IDLE-UP
PROG MIX1
PROG MIX2
CH3
CH4
LAP STAR
LAP RESET
4WS MIX
OFF
When push switch (PS1,PS2,PS3) is operated in the opening screen state, the state of the
function is displayed in the upper-right corner for about two seconds.
Example :4WS Mixes
PS1
PS2
(SW1/SW2/SW3)
Start function /Preset (Engine cut)
Neutral brake function ON/OFF
A.B.S function (2CH)ON/OFF
A.B.S function (3CH,4CH)ON/OFF
2nd condition function ON/OFF
Idle up function ON/OFF
Program mixing1 function ON/OFF
Program mixing2 functionON/OFF
channel 3
channel 4
Timer function start (SW3 not possible)
Timer function reset (SW3 not possible)
4WS mixing type select
Not used
Function Select Switch "SWTCH"
Function name, etc
When the set SW is operated in
the opening screen state, the 4WS
mode is displayed here for about 2
seconds.
PS3
89