Idle-Up "Idlup - FUTABA 1M23N20718 Instruction Manual

Idle-Up "IDLUP"

This is a function select switch function. The idle-up function ON/OFF switch must be
set. (Page 88)
It is used to improve engine starting performance by raising the idling speed when the
engine of a gasoline car (boat) is started.
This function is also effective when you want to prevent braking when the power was
turned off during running due to the effect of gear ratio setting and the motor used with
a motor car. However, when using the MC950CR, MC851C, MC602C, MC402CR, etc.,
check the ESC neutral position and set the idling function switch to ON after the set en-
ters the operation mode, the same as the neutral brake function (page 80).
Operation
The throttle neutral position is offset to the forward side or brake side. There is no link-
age locking, etc. because there is no change near the maximum operation angle even
when the neutral position is offset by this function.
Calling the setup screen
*Calling from menu screen
(Opening Screen)
MENU 1
MENU 2
Press t
* When the direc t c all but ton
is set, the setup screen is also
called by the following method:
(Opening Screen)
DIRECT SEL
Press the button set
at this function.
Idle-Up function adjustment
(Preparation)
- Use the function select switch function to select the switch. (page 88)
1
(Idle-Up rate)
Use the (+) and (-) buttons to set the Idle-Up rate.
2
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
82
Operation Display
While this function is ON, the LED blinks. (When LED
is active)
screen.
Menu screen call
by button
MENU1/2 selection
by button
Select the function
by button
he button
If the power switch is turned on
Press t
he button
while the idle-up switch is on, an
audible alarm will be heard. Im-
mediately set the Idle-Up switch
to OFF.
also appears on the initial screen and menu
Idle-Up "IDLUP"
(Throttle system)
Idle-Up on/off state.
The LED blinks while the Idle-Up
function is on.
Warning display
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Idle-Up rate (RATE)
D50% ~ D1%, 0%, U1% ~ U50%
Initial value: 0%
"D": Brake side
"U": Forward side