Iq 5 Light Image - Xerox WORKCENTRE 3119 Service Manual

IQ 5 Light Image

Description
The printed image is light, with no ghost.
WorkCentre 3119
Check and Cause
1. Toner Save mode enabled.
2. Check shading profile in Tech
Mode, GP 5.
3. Bad contact caused by dirty con-
tacts on the toner cartridge.
4. Ambient temperature is below
than 10°C.
5. The toner is not properly distrib-
uted in the cartridge.
6. A ticking noise occurs. Measure
the time between 'ticks'.
7. The toner cartridge life has
expired.
8. Develop roller is contaminated
when the toner has almost
depleted.
9. Check the HVPS output using
Engine Test Mode, GP 4.
06/06
Image Quality
Solution
1. Ensure the Toner Save mode is
off, GP 3. Check printer and driver
settings.
2. Redo shading profile in the Tech
mode, GP 5.
3. Clean the following parts:
• Toner cartridge contacts, PL 1
• MEC-TERMINAL, PL 3
• IPR-P-Terminal CON, PL 3
Clean all dirt from inside the frame
assembly, PL 3.
4. Wait 30 minutes after the printer
has powered on before you start
printing.
5. Remove the toner cartridge, PL
1, gently shake it and replace.
6. If the ticks occur between 2 sec-
ond intervals, the toner cartridge is
almost exhausted. Install a new
toner cartridge, PL 1.
7. Install a new toner cartridge, PL
1.
8. Install a new toner cartridge, PL
1.
9. If necessary, install a new SMPS/
HVPS, PL 1.
3-7