Installing The Ceiling Panel; When Removing The Ceiling Panel For Servicing - Sanyo SPW-X483GH56 Installation Instruction

10-4.

Installing the Ceiling Panel

(1) Lift the ceiling panel and position it to align the
panel catches with the catch recesses of the
1 1 1 1 1
indoor unit.
AS (2) Hook the stationary catch first and then press up
on the opposite side to engage the level catch to
install as shown in Figs. 10-5 and 10-6.
2 2 2 2 2
NOTE
S
The ceiling panel must be mounted correctly. Listen for
the click to determine it is securely shut.
3 3 3 3 3
(3) Next, check to see that the ceiling panel is prop-
erly aligned with the seamline of the ceiling. If it is
X
not, remove the ceiling panel and slightly readjust
the indoor unit body to the proper suspension
point.
(4) When the ceiling panel has been properly
aligned, use the 4 supplied mounting screws (M5)
with washers to permanently fasten the ceiling
panel.
(5) Install the wiring connector from the ceiling panel
to the connector in the electrical component box
of the indoor unit (15P connector if heat pump
model). After installing the connector, use the
clamp on the body of the indoor unit to secure the
wiring.
NOTE
If the connector is not connected, a misoperation
signal ("P9" on the remote control display) will be
displayed when the unit is turned on.
(6) Install the air filter and air-intake grille by perform-
ing the steps in Figs. 10-3 and 10-4 in reverse.
10-5. When Removing the Ceiling Panel for
Servicing
When removing the ceiling panel for servicing, remove
the air-intake grille and air filter, disconnect the wiring
connector inside the electrical component box, and
then remove the 4 mounting screws.
0 0 0 0 0
Release one side of the panel by pressing the panel
catch in the direction of the arrow(*). Completely
C
remove the ceiling panel by disengaging the stationary
catch. (Fig. 10-6)
Panel catch
(stationary side)
4 pcs.
Fig. 10-5
Panel catch (stationary side)
Fig. 10-6
Fig. 10-7
80 80
S4179544 S4179544
Ceiling panel
Panel catch
(level catch side)
0146_S_I
Panel catch (level catch side)
0147_S_I
Electrical component box
Connector
0148_S_I