How To Install The Remote Controller (Optional Part); When Using A Wall Box For Flush Mounting - Sanyo SPW-X483GH56 Installation Instruction

6. HOW TO INSTALL THE REMOTE CONTROLLER
(OPTIONAL PART)
Remote controller wiring can be extended to a maximum
of 1,000 m.
How to install the remote controller
(Optional Controller)
CAUTION
The mounting position for the remote controller should
be located in an accessible place for control.
Never cover the remote controller or recess it into the
wall.
(1) When you open the decorative cover, you will see
two gaps under the remote controller. Insert a
coin into these gaps and pry off the back case.
(Fig. 6-2)

6-1. When Using a Wall Box for Flush Mounting

If local codes allow, this remote controller can be
mounted using a conventional wall box for flush
mounting.
(2) Attach the back case with the 2 small screws
provided. Using a screwdriver, push open the cut-
outs on the back case. These holes are for
screws. Use the spacers and take care not to
tighten the screws excessively. If the back case
will not seat well, cut the spacers to a suitable
thickness. (Fig. 6-1)
(3) Connect the remote controller wiring (3 wires)
correctly to the corresponding terminals in the
electrical component box of the indoor unit.
When wiring, do not connect
the remote controller wires
CAUTION
to the adjacent terminal
block for the power wiring.
Otherwise, the unit will break
down.
(4) To finish, fit the back tabs of the case into the
remote controller and mount it.
Do not twist the control
wiring with the power
wiring or run it in the
same metal conduit,
because this may cause
malfunction.
Install the remote control-
ler away from sources of
electrical noise.
Install a noise filter or
take other appropriate
action if electrical noise
affects the power supply
circuit of the unit.
CAUTION
Switch box for 1 (no cover)
or switch box for 2 (no cover)
M4 x 25
Screws (2)
Weekly
timer
Decorative
cover
Decorative
cover
No. Accompanying parts Q'ty
Remote controller
(comes with
1
1
20 cm wire)
Machine screws
M4x25
2
2
Wood screws
3
2
Spacers
4
2
61
S4179544
Do not supply power to the
unit or try to operate it until
the tubing and wiring to the
outdoor unit is completed.
Spacer
Under case
(Back case)
Fig. 6-1
0194_M_I
Control panel
Gap
Gap
Coin
Fig. 6-2
0158_M_I
No. Accompanying parts Q'ty
Clamper
5 5
Wire joints
6
6
2
3
0 0 0 0 0
C
- - - - -
RC
= = = = =
WT