Basic Wiring Diagram; Wiring System Diagram For Multiple Remote Control - Sanyo SPW-X483GH56 Installation Instruction

6-4. Wiring System Diagram for Multiple Remote
Control
When Installing Multiple Remote Controllers
This multiple remote controller system is used for
operating the unit(s) at different positions. (A maximum
of 2 remote controllers can be installed.)
Setting method
To execute this control, make the setting according
to the following procedure.
(1) Of the two installed remote controllers, make one
the main remote controller (factory-shipped
state).
(2) On the other remote controller, turn the address
switch on the PCB from OFF to ON.
In this state, it functions as a sub-remote
controller.

Basic wiring diagram

CAUTION
To operate 1 indoor unit with 2 remote controllers
set at different places.
0 0 0 0 0
C
- - - - -
RC
= = = = =
WT
Install wiring correctly
(incorrect wiring will damage
the equipment).
Remote Controller
Address switch
(main)
Option
1 2 3
3P terminal base
Earth
64
S4179544
Refrigerant
circuit
terminal
0802_M_I
(sub)
Option
1 2 3
Connection wiring
for remote controller
(field work, total
White
length up to 500m)
Red Black
1 2 3
Indoor unit
0168_M_I