Table of Contents
Advertisement
3-16.
Installing the Rear Panel onto the Wall
Confirm that the wall is strong enough to support the
unit.
See either Item a) or b) below depending on the wall
type.
a) If the Wall is Wooden
(1)
Attach the rear panel to the wall with the 8 screws
provided. (Fig. 3-51)
If you are not able to line up the holes in the rear
panel with the beam locations marked on the
wall, use Rawl plugs or toggle bolts to go through
the holes on the panel or drill 5 mm dia. holes in
the panel over the stud locations and then mount
the rear panel.
(2)
Check with a tape measure or carpenter’s level.
This is important so that the unit is correctly
installed. (Fig. 3-52)
(3)
Make sure the panel is flush against the wall. Any
space between the wall and unit will cause noise
and vibration.
b) If the Wall is Brick, Concrete or Similar
Drill 4.8 mm dia. holes in the wall. Insert Rawl plugs for
appropriate mounting screws. (Fig. 3-53)
3-17.
Removing the Grille to Install the Indoor
Unit
For preventing the
movement of the air-
CAUTION
deflector blades during
transportation, a protective
gasket was mounted at the
air outlet of the air
conditioner. Remove the
gasket before installation.
(Fig. 3-54)
Before wiring, you should remove the grille as follows:
How to remove the grille
(1)
Set the flap in the horizontal position.
(2)
Remove the screws. (Fig. 3-55)
(3)
Remove the grille.
(4)
When replacing the grille, push the grille at the
mark ( ) as shown in Fig. 3-56 until the grille
clicks back into place.
0070_K_I
Fig. 3-51
0071_K_I
Fig. 3-52
4 4 4 4 4
4.8 mm
dia. hole
K
Rawl plug
0072_K_I
Fig. 3-53
Protective gasket
0073_K_I
Fig. 3-54
0074_K_I
Fig. 3-55
Mark ( )
Push
Mark ( )
Magnification
of mark
0075_K_I
Fig. 3-56
Page 35
Hide quick links:
Advertisement
Chapters
Table of Contents
