Analog Input/Digital Input/Digital Output/Analog Output - Honeywell HC900 User And Installation Manual

Analog Input/Digital Input/Digital Output/Analog Output

A single DI/DO/AO-RTP and cable is used with the following modules:

4-point Analog Output

16-point Contact Digital Input

16-point DC Digital Input

16-point AC Digital Input

16-point DC Digital Output

8-point AC Digital Output

8-point Analog Output
Dual DI/DO/AO-RTPs and cables are used with the following modules:

16-point Analog Output

16-point Analog Input

32-Point DC Digital Output

32-Point DC Digital Input
4 Point Analog Output
Step
1
ATTENTION: RTP and cables are intended for permanent installation within their own enclosure.
Mount RTP cable assembly to HC900 Controller (Figure 96).

Remove appropriate key tabs from terminal block to allow mating with the module. See page 85.

Connect desired cable to AO module at controller. Choose from:
900RTC-L010
900RTC-L025
900RTC-L050

Install AO module label onto the module connector cover.

Connect shield drain wire to the grounding bars at the base of the HC900 rack. All field-wiring
shields must be grounded as described in the shield grounding section (page 81).
2
Mount RTP to DIN rail.

Latch to rail. See page 253.

Connect cable to RTP
Revision 6
21 April 2017
Remote Terminal Low Voltage Cable Assembly, 1.0 meters long
Remote Terminal Low Voltage Cable Assembly, 2.5 meters long
Remote Terminal Low Voltage Cable Assembly, 5.0 meters long
HC900 Process & Safety Controller User and Installation Manual
See page
See page
Action
229
231
232
234
235
238
241
244
245
248
250
229