Table of Contents
Advertisement
88 BODY MANUAL
WINDOW ADJUSTMENTS
QUARTER WINDOW:
Before attempting any door window adjustments, the
quarter window must be properly positioned as follows:
1. Loosen screws (R) Figure 138, to obtain the proper
forward adjustment.
2. Insert rubber shims under the front edge of the rear
quarter window to align the rear quarter window with the
door glass.
NOTE: In the fully raised position, the front edge of the
quarter window rests on the rubber weatherstrip on the
door lock pillar.
DOOR WINDOW:
The door glass has four, adjustments to provide proper
alignment with the top side rails and the rear quarter
window as follows:
FIGURE 143
1. To bring the rear of the door glass into alignment with
the rear quarter window, the glass run channel may be
adjusted in or out by moving screw (N) Figure 143,
attaching the channel to the lock edge of door.
2. If satisfactory adjustment cannot be made at this point
due to bottom of channel striking the door outer panel, it
will be necessary to remove the channel and cut off part of
the lower outer corner of the channel to allow outward
adjustment of the channel to the limit of the adjusting
screw slot. In extreme cases it may be necessary to extend
the screw slot by filing the slot with a round file. 3. The
adjustable window stops shown at (P) Figure 144, which
are accessible when the door garnish moulding is re-
moved, are for the purpose of making minor adjustments
of the door window travel to assure full contact with the
side rail weatherstrip.
FIGURE 144
4. The hydraulic window regulator mounting is slotted to
allow raising, lowering, or tilting forward or rearward of
the regulator as required see (H), Figure 145.
5. The door window glass rest channel is also slotted and
may be adjusted in the same manner as the regulator
assembly.
FIGURE 145
VENT WING:
1. Remove two screws (S) Figure 138, attaching the wing
cradle to inner panel.
2. Loosen screw (T) attaching center glass channel to
upper edge of inner panel and remove screw (U) attaching
lower end of center channel to inner panel.
Advertisement
Table of Contents
