Door Trim Panel; Door Window Regulator - Hudson 480-490 Series Service Manual

480-490 series
Table of Contents

Advertisement

28 BODY MANUAL
6. If door opens easily without pushing the handle button,
loosen screws as in step one and rotate bottom of striker
plate inward. (C). Tighten screws and re-check.
FIGURE 26
DOOR OUTSIDE HANDLE
REMOVAL:
To remove the door outside handle, remove Phillips head
screw (A), Figure 26, from edge of door. Push handle
forward and lift handle out of door.
INSTALLATION:
To install, reverse procedure of removal.

DOOR TRIM PANEL

(Front and Rear)
REMOVAL:
1. Remove inside door handles.
2. Remove lock release knob and garnish moulding.
3. Remove two screws from underside of arm rest and
remove arm rest.
4. Remove valance by extracting exposed screws and
sliding valance up from between door and trim panel.
5. Remove door pocket trim board (clips).
6. Remove door trim panel (clips).
INSTALLATION:
1. Repair any damage to door inside liner with Mystik
tape before replacing trim panel.
2. Install door trim panel by engaging the bottom retainer
and aligning the clips before driving in place.
3. Install pocket trimboard.
4. Install valance by inserting lower flange between door
and pocket trimboard; and, with slots in line with trim-
board clips, force valance down into position and install
screws.
5. Install arm rest, garnish moulding, lock release knob,
and door handles.
FIGURE 27

DOOR WINDOW REGULATOR

REMOVAL:
1. Remove trim panel. See Page 28.
2. Remove garnish moulding spacer wood block.
3. Cut inner liner as shown in Figure 27 for sedans and
Figure 28 for coupes and broughams.
4. Remove screw (A) from inside upper end of center
glass channel and screws (B) which attach center glass
channel to door inner panel. (Do not remove center glass
channel from door.)
5. Remove screws (C) attaching regulator to door inner
panel.
6. Lower window to bottom of door and release regulator
cross arms from glass channel on sedans. On coupes and
broughams disconnect regulator from cross arm assem-
bly. (A stud on the regulator arm is retained in the cross
arm assembly by a spring clip.)
7. Remove regulator through opening in bottom of door.
(Front)

Advertisement

Table of Contents
loading

This manual is also suitable for:

480 series490 series

Table of Contents