Door Glass - Hudson 480-490 Series Service Manual

DOOR GLASS

(Front)
REMOVAL:
1. Remove safety lock knob and garnish moulding.
2. Remove small wood block.
3. Remove pocket trim panel.
4. Cut door inner liner as shown in Figure 28.
5. Remove Phillips head screw (A),
6. Remove two screws (B).
7. Remove center glass channel (D) or lower lt into
the door.
8. Tilt glass inward and raise to upper limit of regula-
tor.
9. Release regulator cross arms from glass channel
and remove glass and glass channel.
INSTALLATION:
Reverse procedure of removal.
DOOR GLASS
REMOVAL:
1. Remove safety lock knob and garnish moulding.
2. Remove small wood block.
3. Run glass to within 2" of the top and pull inward on
top of glass to release glass from glass runs.
4. Tip glass inward and further raise window until
glass channel can be released from regulator.
5. Remove glass and glass channel.
INSTALLATION:
1. Insert channel and glass through opening and en-
gage regulator.
2. Run regulator up and down to force glass into
position.
3. Replace wood block.
4. Replace garnish moulding and safety lock knob.
QUARTER TRIM PANEL
(Broughams and Coupes)
REMOVAL:
1. Remove rear seat cushion and rear seat back.
2. Remove quarter window regulator handle.
(Rear)
BODY MANUAL
3. Remove garnish moulding.
4. On Commodore models remove valance.
5. Remove two screws from under side of arm rest and
remove arm rest.
6. Remove pocket trim panel and lower trim panel, at-
tached by clips to inner panel.
INSTALLATION:
Reverse procedure of removal.
QUARTER WINDOW GLASS
(Broughams and Coupes)
REMOVAL:
1. Remove garnish moulding and small wood block._
2. Lower window and release three clips attaching glass
run channel to top of window opening by pulling in on
channel.
3. Remove glass run channel.
4. Pull in on top of glass and raise glass to limit of regulator.
5. Release regulator from glass channel and remove glass
and channel.
INSTALLATION:
1. Pull in on top of inner panel to enlarge opening between
inner and outer panels.
2. Insert glass and glass channel through • opening and
engage regulator.
3. Lower the window and apply a coating of cement to
window opening to seal glass run channel.
4. Insert glass run channel and engage clips in top of
window opening.
5. Raise window and replace wood block and garnish
moulding.
QUARTER WINDOW GLASS
(Business Coupes)
REMOVAL:
1. Removal garnish moulding.
2. Remove small wood block.
3. Remove two screws holding window support to inner
panel. Hold window in position and remove support.
4. Lower glass to free it from glass run channel and lift
out.
INSTALLATION:
Reverse procedure of removal.
31