Hudson 480-490 Series Service Manual page 36

30 BODY MANUAL
FIGURE 31
DOOR REMOTE CONTROL
(Front and Rear)
REMOVAL:
1. Remove door trim panel. See page 28.
2. Cut door inner liner as shown at A, Figure 30, for front
door or Figure 31, for rear door.
3. Remove three Phillips head screws (E) from triangular
bracket at handle end of remote control arm.
4. Remove anti-rattle spring and pin
(D) from lock end of remote control and withdraw remote
control toward the hinge side of the door.
INSTALLATION :
Reverse procedure of removal. Repair door inner liner
with Mystik tape.
DOOR VENTILATOR WING
REGULATOR
(Commodore)
REMOVAL:
1. Remove door trim panel. See page 28.
2. Cut door inner liner at B in Figure 30.
3. Remove screw from regulator clevis.
4. Remove two screws (F) attaching regulator to door
inner panel and remove regulator down and out through
opening
in bottom of door inner panel.
INSTALLATION:
Reverse procedure of removal and repair door inner
liner with Mystik tape.
DOOR VENTILATOR WING
(Commodore)
REMOVAL:
1. Remove safety lock knob and garnish moulding.
2. Remove ventilator regulator handle and valance.
3. Remove garnish moulding spacer wood block.
4. Cut hole in door inner liner as shown at B in Figure
30 to expose clevis (G) connecting wing to regulator
and remove screw from clevis.
5. Open ventilator wing and press down on top of
frame to release it from upper pivot and lift out venti-
lator.
INSTALLATION:
Reverse procedure of removal. Make sure ventilator
weatherstrip lip is over garnish moulding. Repair
inner liner.
DOOR VENTILATOR WING
(Super)
REMOVAL:
1. Remove safety lock knob and garnish moulding.
2. Remove wood spacer block.
3. Remove screws (B), Figure 27, attaching wing
frame to inner panel.
4. Remove small Phillips head screw (D), Figure 27,
from top of door.
5. Remove screw (A), Figure 27, from inside upper
end of center glass channel.
6. Tilt ventilator assembly and lift out.
7. Remove nut and spring from friction pivot.
8. Remove screw from top of channel to release wing
from channel.
INSTALLATION:
Reverse procedure of removal. Make sure lip of
weatherstrip is over garnish moulding.