Hudson 480-490 Series Service Manual page 30

24 BODY MANUAL
FIGURE 19
HOOD LOCK LOWER SUPPORT
REMOVAL:
1. Disconnect flood lock control wire.
2. Remove 4 bolts attaching hood lock lower support to
fender tie panel and remove lower support from car.
FIGURE 20
INSTALLATION:
Reverse procedure of removal. Lock hood control wire
securely and apply water resistant grease to hood lock
release catch.
FENDER TIE PANEL AND HOOD
LOCK LOWER SUPPORT
REMOVAL:
1. Raise hood and disconnect hood lock control wire.
2. Remove two bolts (each side) attaching fender tie
panel and hood lock support to fender bracket.
3. Remove two bolts attaching the fender tie panel and
hood lock support to radiator mounting channel.
4. Remove two bolts attaching fender tie panel to the
front fender skirt.
5. Removing one bolt attaching hood lock support to
radiator grille center support and remove the support
assembly from the car.
INSTALLATION:
Reverse procedure of removal.
HEADLINING
Preparatory to headlining removal, remove the follow-
ing trim parts:
A Sun visors
B Rear view mirror
C Front dome lamp lens assembly
D Upper and lower windshield garnish moulding
E Windshield inside center trim bar
F Windshield retainers
G Windshield glass
H Rear seat cushion, back rests, and center arm rest
I Rear window
J Rear package shelf
K Rear quarter window garnish mouldings
L Rear dome lamp lens assembly
NOTE: HANDS MUST BE CLEAN AT ALL
TIMES WHEN WORKING ON THE INTERIOR
TRIM OF A BODY.
REMOVAL:
1. Remove upholsterer's tacks from around rear window
opening and rear quarter window openings and the
cardboard tacking strips at the extreme rear edge of the
headlining on the package shelf. Pull headlining loose
from cement.