Table of Contents
Advertisement
FIGURE 128
2. Depress the unit spring retaining clips with tool KMO-
685 while pressing in on the control knob, Figure 128.
3. With a wire, push the brass pivot pin out toward the end
of the switch case and remove the pin, Figure 129.
FIGURE 129
INSTALLATION:
Reverse procedure of removal, placing the insulator into
the opening in the plastic case before starting the switch
unit into the switch case.
The unit should be assembled ln the case with terminal
post marked "MOT" toward the top of the case.
DOOR TRIM PANEL
(Commodore Series - Convertible)
REMOVAL:
1. Disconnect battery cable at negative battery terminal.
2. Remove vent wing regulator handle and inside door
handle.
3. Remove remote control knob (unscrew), garnish
moulding, and valance
4. Remove two screws from under side of arm rest and
remove arm rest.
5. Remove window regulator switch (electric) using tool
KMO-685, Figure 127.
NOTE: The door trim can be removed at the left door
without disconnecting wires from the switch by tipping
the switch sideways and pushing the switch through
the panel opening. At the right side, the switch must be
disconnected before the panel can be removed'.
6. Remove door pocket trim panel, (clips).
7. Remove door trim panel ash receptacle and pocket
moulding (clips). Pocket moulding is retained by the same
clips that hold the door trim board.
8. Remove door pocket corner trim and fillers front and
rear (cemented). Care must be taken in the removal of the
front and rear corner fillers and trim leather to allow
reassembling with good appearance.
DOOR TRIM PANEL
(Super Series - Convertibles)
REMOVAL:
Follow the same procedure as outlined for the Commo-
dore Series, except as follows:
1. The trim cloth or leather cemented tc the pocket bottom
and front and rear corners are also part of the door trim-
boards (held by staple clips) and care should be used in
removal.
2. Window regulator and inside door handles are held in
place by pin retainers. Depressing the escutcheon and
spring will allow removal of the retainer pins.
DOOR TRIM PANEL INSTALLATION:
1. Cement pocket front and rear corner fillers to the door
with trim cement.
2. Apply coating of trim cement over corner fillers and
apply corner trim.
3. Lay pocket moulding in place.
4. On left-hand door draw the window regulator switch
through the opening in pocket panel and install pocket
panel. 5. Install the door trim board by engaging the
bottom retainer and aligning the clips before driving in
place.
BODY MANUAL
81
Advertisement
Table of Contents
